|
|
 |
 |
|
Divider Strips |
White alloy of zinc, brass or plastic are used for function and aesthetics.
Brass and plastic may have a reaction with some resinous materials and should
be used only if deemed safe by the supplier of the resin.
The following are the most common types of strips available (in some systems,
the strips act as control joints).
1-1/4 inch Standard Divider Strip with anchoring device. Available in
white alloy of zinc or brass and 14, 16 or 18 B & S gauge. Extensively
used in Sand Cushion, Bonded to Concrete, Structural and other types of
cementitious terrazzo systems. Also used in monolithic terrazzo where slab
has been recessed or sawn to create a weakened vertical plane. Available
in 1-1/2 inch and greater depths for Venetian Terrazzo control joints and
special conditions.
1-1/4 inch Heavy Top Divider Strips with anchoring device. Available in
white alloy of zinc or galvanized steel bottom section. Top section available
in white alloy of zinc, brass or colored plastic. Width of the top section
is 1/8, 1/4, 3/8, or 1/2 inch. Basic use is the same for the 1-1/4 inch
Standard Divider Strip. (Some plastic strips are 3/16 inch and 5/16 inch
instead of 1/8, 1/4 and 1/2 inch).
K or L Strips in standard gauges or with
the heavy top feature for use in monolithic
or resinous “thin-set” systems.
Sizes vary according to the depth of the
terrazzo topping. Can be attached to substrate
with
adhesive compatible with topping matrix. |
|
|
| |
|
|
